Configuring The Ethernet Controller; Lenovo Toolscenter Suite Cli Program; Using Lenovo Xclarity Administrator - Lenovo HX3510-G Installation And Service Manual

Step 3. Click Log in to start the session. The System Status and Health page provides a quick view
of the system status.
Note: If you boot to the operating system while in the IMM2 GUI and the message "Booting OS or in
unsupported OS" is displayed under System Status ➙ System State, disable Windows 2008 or 2012
firewall or type the following command in the Windows 2008 or 2012 console. This might also affect
blue-screen capture features.
netsh advfirewall firewall set icmpsetting type=8 mode=ENABLE
By default, the icmp packet is blocked by Windows firewall. The IMM2 GUI will then change to the "OS
booted" status after you change the setting as indicated above in both the Web and CLI interfaces.

Configuring the Ethernet controller

Use this information to configure the Ethernet controller.
The Ethernet controllers are integrated on the system board. They provide an interface for connecting
to a 10 Mbps, 100 Mbps, or 1 Gbps network and provide full-duplex (FDX) capability, which enables
simultaneous transmission and reception of data on the network. If the Ethernet ports in the server support
auto-negotiation, the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and
duplex mode (full-duplex or half-duplex) of the network and automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you must install a device driver to
enable the operating system to address the controllers.
To find device drivers and information about configuring the Ethernet controllers, go to
http://www.lenovo.com/support.

Lenovo ToolsCenter Suite CLI program

The Lenovo ToolsCenter Suite CLI program is a collection of server management tools. Lenovo ToolsCenter
Suite CLI also covers the configuration function, which is an alternative to the Setup Utility for modifying
UEFI settings.
Lenovo ToolsCenter Suite CLI has the following features:
• Utilizing a command line interface to manage firmware, hardware, and operating systems
• Modifying UEFI settings from the command line without restarting the system to access the Setup Utility
• Configuring the optional remote presence features or other IMM2 settings
• Providing IMM2 LAN over USB interface configuration and issuing setup commands through the
command-line interface
• Scripting environments through a batch-processing mode
• Saving any of the settings as a file and running the file as a script
For more information and to download the program, go to
https://support.lenovo.com/us/en/documents/LNVO-CENTER.

Using Lenovo XClarity Administrator

The initial setup of Lenovo XClarity Administrator includes the following:
• Preparing the network
• Installing and configuring the Lenovo XClarity Administrator virtual appliance
.
Chapter 2 Configuration information and instructions
43