Removing The Dedicated Slotless Hba Controller - Lenovo HX3510-G Installation And Service Manual

Shipping bracket for
riser-card assembly
Figure 76. Riser-card assembly installation - full-height, full-length adapters
Step 6. Replace the top cover (see "Replacing the top cover" on page 118).
Step 7. Slide the server into the rack.
Step 8. Reconnect the power cords and any cables that you removed.
Step 9. Turn on the peripheral devices and the server.

Removing the dedicated slotless HBA controller

Use this information to remove the dedicated slotless HBA controller.
The dedicated slotless HBA controller can be installed in the dedicated connector on the system board (see
"System-board internal connectors" on page 23 for the location of the connectors).
To remove the dedicated slotless HBA controller, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Removing and replacing
guidelines" on page 101.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the top cover (see "Removing the top cover" on page 116).
Step 4. Disconnect the signal cables from the connectors on the controller and note their locations.
Step 5. 1 Press the retention tabs away from the controller; then, slightly lift up the rear of the controller,
and 2 pull it out of the connector on the system board.
PCI riser-card assembly 2
PCI riser-card assembly 1
.
Chapter 5 Removing, and replacing components
147