Lenovo HX3510-G Installation And Service Manual page 35

Fan cage
SATADOM bracket
3.5-inch HDD hot-swap
backplane with 8HDDs
3.5-inch hot-swap hard disk drive
2.5-inch hot-swap hard disk drive
Figure 18. Server components
Blue on a component indicates touch points, where you can grip the component to remove it from or install
it in the server, open or close a latch, and so on.
Orange on a component or an orange label on or near a component indicates that the component can be
hot-swapped, which means that if the server and operating system support hot-swap capability, you can
remove or install the component while the server is running. (Orange can also indicate touch points on
hot-swap components.) See the instructions for removing or installing a specific hot-swap component for
any additional procedures that you might have to perform before you remove or install the component.
System-board internal connectors
The following illustration shows the internal connectors on the system board.
cover
Power paddle module
Air baffle
Fan
2.5-inch filler panel
SATADOM
LCD panel
Front USB assembly
Operator information panel assembly
Front control panel assembly
2.5-inch advanced operation panel assembly
PCI riser-card assembly
Heat sink
Microprocessor
System board
Right EIA assembly
Left video EIA assembly
Media cage
.
Chapter 1 The Lenovo Converged HX Series server
DIMM
Power supply
Power supply
filler panel
Riser cage filler
Chassis
Right functional
EIA assembly
23