Removing The Front Usb Connector Assembly - Lenovo TD200 - ThinkServer - 3809 Hardware Maintenance Manual

1
Power supply support bracket
2
Power supply release tab
5. Install the side cover (see "Installing the side cover" on page 252).
6. Lock the side cover.
7. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.

Removing the front USB connector assembly

To remove the front USB connector assembly, complete the following steps.
Step 1. Read the safety information (see Chapter 2 "Safety information" on page 3).
Step 2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
Step 3. Unlock and remove the side cover (see "Removing the side cover" on page 146).
Step 4. Rotate the power-supply cage assembly out of the chassis. Lift up the power-supply cage handle
and pull the power-supply cage assembly all the way up until the retainer latch locks the cage in
place on the chassis.
152
ThinkServer TD200 Hardware Maintenance Manual