Removing The Front Usb Connector Assembly - Lenovo ThinkServer TD200 Installation And User Manual

5. Install the side cover (see "Installing the side cover" on page 134).
6. Lock the side cover.
7. Reconnect the external cables and power cords; then, turn on the attached

Removing the front USB connector assembly

To remove the front USB connector assembly, do the following:
1
Power supply support bracket
2
Power supply release tab
devices and turn on the server.
1. Read the safety information (see "Safety" on page vii and "Installation
guidelines" on page 37).
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see "Removing the side cover" on page
43).
4. Rotate the power-supply cage assembly out of the chassis. Lift up the
power-supply cage handle and pull the power-supply cage assembly all the
way up until the retainer latch locks the cage in place on the chassis.
Chapter 5. Installing optional devices and replacing customer replaceable units
49