Removing The Front Usb Connector Assembly - Lenovo System x3630 M4 Installation And Service Manual

Hide thumbs Also See for System x3630 M4:

Table of Contents

8. If you have the optional hot-swap rear hard disk drive cage installed, rotate it down (see "Rotating the

optional hot-swap rear hard disk drive cage down" on page 181).

9. Install the server top cover (see "Replacing the server top cover" on page 321).

10. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices

and the server.

Removing the front USB connector assembly

Use this information to remove the front USB connector assembly.

To remove the front USB connector assembly that is inside the media cage, complete the following steps:

1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 36.

2. Turn off the server (see "Turning off the server" on page 26) and all attached peripheral devices.

Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.

3. Remove the server top cover (see "Removing the server top cover" on page 320).

4. Remove the PCI riser-card assembly (see "Replacing a PCI riser-card assembly" on page 237).

5. Remove the air baffle (see "Removing the air baffle" on page 322).

6. Locate the USB, video, CD/DVD and operator information panel cables of the media cage.

7. Disconnect the USB, video, CD/DVD and operator information panel cables from the system board.

Please remember the relevant cable routing.

Front operator

panel 2 cable

Front operator

panel 1 cable

8. Loosen the single thumbscrew that is used to secure the media cage onto the server.

Lenovo System x3630 M4 Installation and Service Guide

CD/DVD drive

CD/DVD drive cable