Lenovo HX3510-G Installation And Service Manual page 50

Select this choice to enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Enable is the default.
• Halt on Severe Error
Select this choice to enable or disable the system from booting into OS, displaying the POST
event viewer whenever a severe error was detected. Disable is the default.
– Storage
Select this choice to view or change the storage device settings.
– Network
Select this choice to view or change the network device options, such as iSCSI.
– Drive Health
Select this choice to view the status of the controllers installed in the blade server.
• Date and Time
Select this choice to set the date and time in the server, in 24-hour format (hour:minute:second).
This choice is on the full Setup Utility menu only.
• Start Options
Select this choice to view or change the start options, including the startup sequence, keyboard NumLock
state, PXE boot option, and PCI device boot priority. Changes in the startup options take effect when you
start the server.
The startup sequence specifies the order in which the server checks devices to find a boot record. The
server starts from the first boot record that it finds. If the server has Wake on LAN hardware and software
and the operating system supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that checks for a disc in the
CD-RW/DVD drive, then checks the hard disk drive, and then checks a network adapter.
This choice is on the full Setup Utility menu only.
• Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot from a file, select a
one-time boot, or reset the boot order to the default setting.
• System Event Logs
Select this choice to enter the System Event Manager, where you can view the POST event log and the
system-event log. You can use the arrow keys to move between pages in the error log. This choice
is on the full Setup Utility menu only.
The POST event log contains the most recent error codes and messages that were generated during POST.
The system-event log contains POST and system management interrupt (SMI) events and all events that
are generated by the baseboard management controller that is embedded in the integrated management
module (IMM).
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the system-event log. Also, after you complete a repair or correct an error, clear the system-event
log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error messages.
– System Event Log
Select this choice to view the system event log.
– Clear System Event Log
Select this choice to clear the system event log.
38
HX3510-G, HX5510, HX5510-C, HX7510 Installation and Service Guide