Removing A Microprocessor And Heat Sink - Lenovo HX3510-G Installation And Service Manual

Figure 165. SATADOM cable routing
Step 8. Install the air baffle if it is removed (see "Replacing the air baffle" on page 120).
Step 9. Install the top cover (see "Replacing the top cover" on page 118).
Step 10. Slide the server into the rack.
Step 11. Reconnect the power cords and any cables that you removed.
Step 12. Turn on the peripheral devices and the server.

Removing a microprocessor and heat sink

Use this information to remove a microprocessor and heat sink.
Attention:
• Microprocessors are to be removed only by trained technicians.
Important: Always use the microprocessor installation tool to remove a microprocessor. Failing to use
the microprocessor installation tool may damage the microprocessor sockets on the system board. Any
damage to the microprocessor sockets may require replacing the system board.
• Do not allow the thermal grease on the microprocessor and heat sink to come in contact with anything.
Contact with any surface can compromise the thermal grease and the microprocessor socket.
• Dropping the microprocessor during installation or removal can damage the contacts.
SATA 0 connector
SATADOM cable
Optical disk drive
connector
.
Chapter 5 Removing, and replacing components
Power connector
Signal connector
207