Removing The Front Usb Connector; Assembly - Lenovo System x3100 M4 Installation And Service Manual

3. Push the front-panel assembly toward the chassis until it clicks into place.
4. Reroute and connect the front-panel assembly cable to the system board (see
connectors" on page 25
5. Install the air duct.
6. Install the side cover (see
7. Stand the server back up in its vertical position.
8. Install bezel (see "Replacing the bezel" on page
9. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
To install the front-panel assembly on the 5U server model with hot-swap power supplies (Model name:
2582-F4x), complete the following steps. For 4U server models with non-hot-swap power supplies, please
see the above sub-section.
1. Carefully turn the server on its side so that it is lying flat.
Attention: Do not allow the server to fall over.
2. Position the front end of the front-panel assembly in the channel above bay 1.
3. Push the front-panel assembly toward the front of the chassis until it clicks into place.
Front panel

assembly

4. Reroute and connect the front-panel assembly cable to the system board (see
connectors" on page 25
5. Install the power-supply cage and the power supplies (see
page 218) and "Replacing the hot-swap power supply cage " on page
6. Push the drives in bay 1 and bay 2 into the drive bays (see
"Replacing the tape drive" on page 167
7. Stand the server back up in its vertical position.
8. Install the upper bezel (see
9. Install the lower bezel (see
10. Install and lock the side cover (see
11. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
Removing the front USB connector assembly
Use this information to remove the front USB connector assembly
for the location of the front-panel connector).
"Replacing the side cover" on page
149).
for the location of the front-panel connector).
for more information).
"Replacing the upper bezel" on page
"Replacing the lower bezel" on page
"Replacing the side cover" on page
"System-board internal
147).
"System-board internal
"Replacing the hot-swap power supply " on
222.
"Replacing the DVD drive" on page 162
152).
151).
147).
.
Chapter 6 Removing and replacing components
and
203