Removing An Adapter - Lenovo HX3510-G Installation And Service Manual

Retention bracket
Figure 78. Dedicated slotless HBA controller installation
Step 7. Route the backplane signal cables. (See "2.5-inch hard disk drive cable connection" on page 112
and "3.5-inch hard disk drive cable connection" on page 115).
Step 8. Connect the signal cables to the controller.
Step 9. Reconnect any cables that you removed.
Step 10. Replace the top cover (see "Replacing the top cover" on page 118).
Step 11. Slide the server into the rack.
Step 12. Reconnect the power cords and any cables that you removed.

Removing an adapter

Use this information to remove an adapter.
Removing an adapter in a riser-card assembly
Use this information to remove an adapter.
This topic describes removing an adapter from a expansion slot in a riser-card assembly. These instructions
apply to PCI adapters such as video graphic adapters and network adapters.
The following illustration shows the locations of the adapter expansion slots from the rear of the server.
Slot 1
Slot 2
Slot 3
Figure 79. PCI riser-card adapter expansion slot locations
The following table describes the maximal card dimension supported in each slot.
Slot 4 Slot 5
Dedicated slotless
RAID connector
Retention bracket
Slot 6
Slot 7
Slot 8
.
Chapter 5 Removing, and replacing components
149