Lenovo HX3510-G Installation And Service Manual page 129

Step 3. If the server has been installed in a rack, press down on the left and right side latches and slide
the server out of the rack enclosure until both slide rails lock.
Step 4. Use a screwdriver to unscrew the cover lock to the open position as shown.
Figure 43. Unscrewing the cover lock
1
Step 5. Push the tab on the cover-release latch,
cover to the rear,
Attention: For proper cooling and airflow, replace the server cover before you turn on the server.
Figure 44. Top cover removal
3 then lift the top cover off the server. Set the top cover aside.
1
2
then fully open the cover-release latch. Slide the top
3
2
Cover-release latch
.
Chapter 5 Removing, and replacing components
117