Removing The Front Usb Connector Assembly - Lenovo x3650 M4 BD 5466 Installation And Service Manual

Hide thumbs Also See for x3650 M4 BD 5466:

Table of Contents

4. Install the screws to secure the front USB connector assembly to the side of the server.

5. Slide the cable arm cover into the retention slots and install the screws to secure it on the side of

the chassis.

Note: The cable is routed on the outside of the chassis and connected to the system board. The cable

must be protected by the cable cover on the side of the chassis.

6. Install PCI riser-card assembly 2 (see "Replacing a PCI riser-card assembly" on page 199).

7. Install the air baffle (see "Replacing the air baffle" on page 250).

8. Rotate the hot-swap rear hard disk drive cage down (see "Rotating the hot-swap rear hard disk drive

cage down" on page 156.

9. Install the server top cover (see "Replacing the server top cover" on page 248).

10. Reconnect the external cables; then, reconnect the power cords and turn on the peripheral devices

and the server.

Removing the front USB connector assembly

Use this information to remove the front USB connector assembly.

To remove the front USB connector assembly that is on the side of the server, complete the following steps:

1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines" on

2. Turn off the server (see "Turning off the server" on page 19) and all attached peripheral devices.

Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.

3. Remove the screws from the cable arm cover; then, slide the cable arm cover towards the rear of

the server and set it aside.

Lenovo System x3650 M4 BDInstallation and Service Guide