Lenovo HX3510-G Installation And Service Manual page 166

Step 4. Determine which expansion slot you will use for the adapter. If you are installing an adapter in PCI
expansion slot 1, 2, or 3, remove riser-card assembly 1; if you are installing an adapter in expansion
slot 6, 7, or 8, remove riser-card assembly 2. See "Removing a riser-card assembly" on page 143
1
Step 5. Slide the retention bracket; then,
Step 6. Slide the expansion-slot cover out of the riser-card assembly expansion slot.
Step 7. Align the adapter with the PCI connector on the riser card and press the adapter firmly into the PCI
connector on the riser card.
Expansion-slot cover
Figure 84. Adapter installation
Step 8. Rotate the retention latch to the close position.
Note: Fasten the screw on the retention latch to secure the adapter.
Step 9. If you are installing a full-height, full-length adapter, insert the shipping brackets.
PCI riser assembly
Figure 85. Full-height, full-length adapter
Step 10. Connect any required cables to the adapter.
Attention:
• When you route cables, do not block any connectors or the ventilated space around any of
the fans.
154
HX3510-G, HX5510, HX5510-C, HX7510 Installation and Service Guide
2
rotate it to the open position.
Bracket
2 1
3
Adapter
Shipping bracket
PCI riser-card assembly
Adapter connector