Updating The Server Configuration; How To Send Dsa Data - Lenovo HX3510-G Installation And Service Manual

Step 21. Reactivate any Feature on Demand features such as the Advanced IMM.
Step 22. Update the Nutanix specific configuration (see "Configuring the HX Series appliance" on page 48).

Updating the server configuration

Use this information to update the server configuration.
When you start the server for the first time after you add or remove a device, you might receive a message
that the configuration has changed. The Setup Utility starts automatically so that you can save the new
configuration settings.
Some optional devices have device drivers that you must install. For information about installing device
drivers, see the documentation that comes with each device.
If you have installed a USB hypervisor memory key on the SAS riser-card, see the user's guide that comes
with the hypervisor memory key. Hypervisor enables guest operating systems to function on the server.
For information about configuring the integrated Gigabit Ethernet controller, see "Configuring the Ethernet
controller" on page 43.

How to send DSA data

You can use the Enhanced Customer Data Repository to send diagnostic data to IBM.
Before you send diagnostic data to IBM, read the terms of use at http://www.ibm.com/de/support/
ecurep/terms.html.
You can use any of the following methods to send diagnostic data:
• Standard upload:
http://www.ibm.com/de/support/ ecurep/send_http.html
• Standard upload with the system serial number:
http://www.ecurep.ibm.com/app/ upload_hw
• Secure upload:
http://www.ibm.com/de/support/ ecurep/send_http.html#secure
• Secure upload with the system serial number:
https://www.ecurep.ibm.com/ app/upload_hw
228
HX3510-G, HX5510, HX5510-C, HX7510 Installation and Service Guide