Removing A Hot-Swap Fan - Lenovo HX3510-G Installation And Service Manual

Release latch
Slots
Figure 64. Fan cage assembly installation
Step 6. Replace the fans, if needed (see "Replacing a hot-swap fan" on page 138).
Step 7. Replace the top cover (see "Replacing the top cover" on page 118).
Step 8. Slide the server into the rack.
Step 9. Reconnect the power cords and any cables that you removed.
Step 10. Turn on the peripheral devices and the server.

Removing a hot-swap fan

Use this information to remove a hot-swap fan.
Attention: To ensure proper server operation, replace a failed hot-swap fan within 30 seconds.
To remove a hot-swap-fan, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Removing and replacing
guidelines" on page 101.
Step 2. Remove the top cover (see "Removing the top cover" on page 116). The LED on the system board
near the connector for the failing single-motor hot-swap fan will be lit.
Attention: It is not necessary to disconnect the power when removing the hot-swap fan. To ensure
proper system cooling, do not remove the top cover for more than 30 minutes during this procedure.
Step 3. 1 Pull the fan latch to the left to release the fan from the fan connector and
of the fan cage.
Fan cage assembly
1
Slots
Release latch
.
Chapter 5 Removing, and replacing components
2 pull the fan out
137