Lenovo HX3510-G Installation And Service Manual page 57

[access_method]
The access method that you selected to use from the following methods:
• Online authenticated LAN access, type the command:
[­­imm imm_user_id:imm_password@imm_internal_ip]
Where:
imm_internal_ip
The IMM2 internal LAN/USB IP address. The default value is 169.254.95.118.
imm_user_id
The IMM2 account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM2 account password (1 of 12 accounts). The default value is PASSW0RD (with
a zero 0 not an O).
Note: If you do not specify any of these parameters, OneCLI will use the default values.
When the default values are used and OneCLI is unable to access the IMM2 using the online
authenticated LAN access method, OneCLI will automatically use the unauthenticated KCS
access method.
Example that does not use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SYsInfoUUID <uuid_value> –user <user_id>
–password <password>
Example that uses the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
• Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this access method.
Example:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
The KCS access method uses the IPMI/KCS interface. This method requires that the IPMI driver
be installed. Some operating systems have the IPMI driver installed by default. OneCLI provides
the corresponding mapping layer. For more details, see the Lenovo ToolsCenter Suite CLI Users
Guide. To access this guide, do the following:
1. Go to http://www.lenovo.com/support.
2. Click the Downloads tab at the top of the panel.
3. Under ToolsCenter, select View ToolsCenter downloads.
4. Select Lenovo ToolsCenter Suite CLI.
5. Scroll down and click the link and download the OneCLI version for your operating system.
Scroll down and look under Online Help to download the Lenovo ToolsCenter Suite CLI
Users Guide.
• Remote LAN access, type the command:
Note: When using the remote LAN access method to access IMM2 using the LAN from a client,
the host and the imm_external_ip address are required parameters.
[­­imm imm_user_id:imm_password@imm_externaln _ip]
Where:
imm_external_ip
The external IMM2 LAN IP address. There is no default value. This parameter is required.
imm_user_id
.
Chapter 2 Configuration information and instructions
45