Removing The Front Usb Connector Assembly - Lenovo x3550 M5 Installation And Service Manual

Four 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
Front USB assembly
connector
Figure 151. Media cage installation for four 3.5-inch hot-swap or simple-swap hard disk drive server
configuration
Step 3. Reinstall the air baffle (see "Replacing the air baffle" on page 122).
Step 4. Reinstall the cover (see "Replacing the cover" on page 120).
Step 5. Slide the server into the rack.
Step 6. Reconnect the power cords and any cables that you removed.
Step 7. Turn on the peripheral devices and the server.

Removing the front USB connector assembly

Use this information to remove the front USB connector assembly.
To remove the front USB connector assembly, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see "Removing the cover" on page 119).
Step 3. Remove the media cage (see "Removing the media cage" on page 228).
Step 4. Remove the front USB connector assembly from the media cage.
Notes:
234
Lenovo System x3550 M5 Installation and Service Guide
Front video
connector