Configuring Ospf Interfaces - 3Com SuperStack II 3300 User Manual

88 C 8: S
HAPTER ETTING
Displaying the
Default Route Metric
Defining the Default
Route Metric
Removing a Default
Route Metric
Configuring OSPF
Interfaces
IP P
ARAMETERS
To display the current default route metric value, enter the following at
the top-level menu:
ip ospf defaultRouteMetric display
The default route metric is displayed:
Default route metric = 1
To define a default route metric for the router:
1 Enter the following at the top-level menu:
ip ospf defaultRouteMetric define
The following prompt is displayed:
Default route metric (1-65535) [1]:
2 Enter the default route metric value at the prompt.
To remove a default route metric from the Layer 3 Module, enter the
following at the top-level menu:
ip ospf defaultRouteMetric remove
The designated default route metric is removed immediately.
This section describes how to configure OSPF interfaces by adding OSPF
characteristics to existing IP Virtual LAN (VLAN) interfaces. You can
configure the following OSPF characteristics on existing IP VLAN
interfaces:
Mode
Priority
Area ID
Cost
Transmit delay
Hello timer
Retransmit timer
Dead interval
Password