54
C
3: W
HAPTER
ORKING
Configuring the
Current Switch
Displaying the Status
of the Ports
W
W
I
ITH THE
EB
NTERFACE
You can configure the current Switch and the ports on that Switch using
the Unit Pages. These pages allow you to:
Display the status of the ports on the Switch
Display the general administration details of the Switch
Set up IP information for the Switch
Configure individual ports on the Switch
Configure the console port of the Switch
You can display the status of ports on the Switch using the Switch
Graphic page.
To access the page:
Click the Unit icon on the side-bar. The Switch Graphic page is
displayed, containing a graphic of the Switch similar to
that this page is always displayed above the other Unit pages.
Figure 6 The Switch graphic
Displaying the Color Codes Used by the Switch Graphic
The Switch graphic indicates the status of a port using color-coding:
Green — Enabled, connected
Black — Enabled, disconnected
Gray (with connection) — Disabled, connected
Gray (without connection) — Disabled, disconnected
You can display the color-coding information using the Color Key page.
To access the page, click the Color Key hotlink under the Switch graphic.
Figure
6. Note