Qos Profile Configuration Task List; Configuring A Qos Profile - 3Com 5500-EI PWR Install Manual

A user-based QoS profile application fails if the traffic classification rule defined in the QoS
profile contains source address information (including source MAC address information,
source IP address information, and VLAN information).
Manual application mode
You can use the apply command to manually apply a QoS profile to a port.

QoS Profile Configuration Task List

Complete the following tasks to configure QoS profile:

Configuring a QoS Profile

Applying a QoS Profile
Configuring a QoS Profile
Configuration prerequisites
The ACL rules used for traffic classification are defined. Refer to the ACL module of
this manual for information about defining ACL rules.
The type and number of actions in the QoS profile are specified.
Configuration procedure
Follow these steps to configure a QoS profile:
To do...
Enter system view
Create a QoS profile
and enter QoS profile
view
Configure traffic
policing
Operation
Use the command...
system-view
qos-profile profile-name
traffic-limit inbound acl-rule
[ union-effect ] [ egress-port
interface-type interface-number ]
target-rate [ burst-bucket
burst-bucket-size ] [ exceed
action ]
Required
Optional
2-2
Description
Remarks
—
Required
If the specified QoS profile
already exists, you enter
the QoS profile view
directly.
Optional