Configuring Advanced Radio Profile Settings - 3Com WX1200 Reference Manual

5 Click Reset To Default.
6 Click OK.
Configuring
Advanced Radio
Profile Settings
After you configure a radio profile, you can select the radio profile, and
click Properties to display a configuration wizard that contains all the
configurable parameters for the radio profile. A dialog with the following
tabs is displayed:
Radio Profile
802.11 Attributes
Auto Tune
Service Profile Selection
Radio Selection
Voice Configuration
Radio Profile Tab
The Radio Profile tab lists settings for the following options:
Name—Radio profile name
Countermeasures Mode:
None—Radios do not use countermeasures. This is the default.
All—Radios use countermeasures against devices classified by MSS
as rogues and against devices classified by MSS as interfering
devices.
A rogue is a device that is in the 3Com network but does not
belong there. An interfering device is not part of the 3Com
network but also is not a rogue. MSS classifies a device as an
interfering device if no client connected to the device has been
detected communicating with any network entity listed in the
forwarding database (FDB) of any WX switch in the Mobility
Domain. Although the interfering device is not connected to your
network, the device might be causing RF interference with MAP
radios.
Rogue—Radios use countermeasures against devices classified by
MSS as rogues, but do not use countermeasures against devices
classified by MSS as interfering devices.
Viewing and Configuring Radio Profiles 267