Table of Contents
Advertisement
MSD-62 Series User's Guide
9.9.10 The number of HDCP retries
Menu
Top→OUTPUT SETTING→HDCP ERROR RETRY
Setting for
Each output channel
Setting value ETERNITY : retries until succeed [Default]
0 to 100
You can set the number of HDCP retries.
If an HDCP-compliant sink device is connected and you set "HDCP" to "ALWAYS" or "HDCP INPUT ONLY",
HDCP is authorized regardless of the status of input signal. Normally, set this menu to "ETERNITY" to retry
the authentication automatically after the first authentication fails. However, you can set the number of retries
manually. (If retry is not succeeded even after the MSD retries for the set number of retry times, video and
audio with HDCP are not output.)
Press the MENU/SET key to apply the setting.
9.9.11 Deep Color
Menu
Top→OUTPUT SETTING→DEEP COLOR OUTPUT
Setting for
Each output channel
Setting value 24-BIT COLOR [Default] 30-BIT COLOR
You can select the color depth of HDMI signal.
"30-BIT COLOR": signals are output with "30-BIT COLOR" only if a sink device supporting Deep Color is
connected.
Since the transmission clock of "30-BIT COLOR" is faster than that of "24-BIT COLOR", noise may occur if a
poor-quality cable or long cable is connected. In those cases, the noise may be removed by selecting"24-BIT
COLOR".
For 4K (3840 x 2160) and 4K (4096 x 2160), the color depth is "24-BIT COLOR".
94
:0 to 100times
Advertisement
Table of Contents
