Table of Contents
Advertisement
■ Finding the sewing position
By locking the needle bar (securing the needle and
presser foot in the down position), the needle drop
point can easily be seen.
a
As shown in the illustration, insert the Allen
screwdriver into the hole in the needle
clamp to slowly lower the needle bar down
till needle bar stops then clicks into the lock
position.
Note
• Make sure that the needle is not lowered
beyond the positioning click into the fabric.
→ The needle and presser foot are locked in the down
position.
b
Touch the arrow keys in the embroidering
settings screen to move the embroidery
frame so that the needle drop point is at the
center of the area where you wish to
embroider.
• With a USB mouse, your finger or the touch pen, drag
the pattern to move it.
• When specifying the starting of stitching, align the
needle drop point with the point specified as the
starting of stitching. (For details on specifying the
starting/ending of stitching, refer to page 135.)
OTHER BASIC PROCEDURES
■ Unlocking the needle bar
a
Display the embroidering screen, and then
touch the key for any needle bar other than
the one that is locked.
→ The needle bar is unlocked and will return to
original position.
Adjusting the angle
Depending on the type of fabric being
embroidered, it may not be possible to stretch the
fabric in the embroidery frame at the desired
angle. In this case, adjust the angle of the pattern
so that it is correctly positioned on the fabric.
a
Touch
.
The following screen appears.
3
99
Advertisement
Table of Contents
Troubleshooting
