Brother 884-T13 Operation Manual page 269

c Lower the L-shaped bracket to make it
touch the machine bed and then tighten the
two hexagonal screws using the Allen
screwdriver (medium). Firmly tighten the
screws.
1 L-shaped bracket
d Using the Allen screwdriver (large), loosen
the four hexagonal screws on the inside of
the ring. Loosen the screws only by about
one turn.
1 Hexagonal screws
2 Allen screwdriver (large)
→ When the screws are loosened, the ring can be
lowered.
Note
• Do not loosen them too far.
e Insert the pad between the machine bed
and the ring of the cap frame driver.
1 Pad
2 Machine bed
3 Ring of the cap frame driver
Lightly press down the ring, and then use
f
the Allen screwdriver (large) to tighten the
four hexagonal screws on the inside of the
ring.
Firmly tighten the screws.
1 Ring
CAUTION
• Make sure that each hexagonal screw is firmly
tightened. If any screw remains loosen, injuries
may result.
g Remove the pad inserted in step
APPENDIX
7
e
.
267