d
Adjust the angle of the operation panel.
Loosen the 2 thumb screws behind the operation
panel, adjust the operation panel to an easy-to-view
angle, and then tighten the thumb screws.
(Side view)
1 Thumb screws
Note
• Using the disc-shaped screwdriver
included, loosen and firmly tighten the five
thumb screws.
28
Preparing the thread guide
assembly
Raise the thread guide assembly.
(Top view)
a
b
CAUTION
• When setting up the thread guide assembly, set
it up with the needle bar 6 position selected,
otherwise the machine may malfunction.
(Refer to "Moving and threading a selected
needle bar" on page 62 for moving the needle
bar.)
Loosen the two thumb screws on top of the
thread guide assembly support.
1 Turn the screw counterclockwise three or four
times to loosen it.
Grab the grips on the thread guide assembly
support and push toward the middle.