Brother 884-T13 Operation Manual page 89

Hold the needle changing tool and press the end of the
needle changing tool 1 in to extend the needle-
mounting clamp 2. Attach the clamp to the needle,
and then release the pressed area to clamp the needle.
To unclamp the needle, press 1 again.
1 End of the needle changing tool
2 Needle mounting clamp
d While holding the needle in place with your
left hand, tighten the needle set screw.
Use the Allen screw driver to turn the needle set screw
clockwise.
CAUTION
• Be sure to insert the needle in the needle bar
chamber until it reaches the needle bar
stopper and securely tighten the needle set
screw with the Allen screw driver, otherwise
the needle may break or the machine may be
damaged.
• If the needle is not fully inserted, the hook of
the automatic needle-threading mechanism
will not pass through the eye of the needle
during automatic needle threading, and the
hook may bend or the needle cannot be
threaded.
• If the hook of the automatic needle-threading
mechanism is bent or damaged, contact your
authorized Brother dealer.
OTHER BASIC PROCEDURES
3
87