Table of Contents
Advertisement
9. Checking the Embroidery Area
Check the embroidery area to make sure that the embroidery will be sewn in the desired location and will
not be misaligned and that the embroidery frame will not hit the presser foot.
If the embroidery frame is not correctly positioned, it moves to the correct position, and then the
embroidering position is indicated.
Note
• If you are embroidering a large project such
as a jacket or curtains, using the flat, quilt or
jumbo frame, your embroidering may be
interrupted by the presser feet not in use
catching on the fabric outside of the design
area. Try to stitch the design as close to the
center of the embroidery frame, using
needle bars 3 through 7, keeping the head
of the machine as centered as possible.
(Refer to page 110 or 132 to select the
needle bar).
a
Touch
.
→ The presser foot is lowered and the embroidery
frame moves to show the embroidery area.
b
The corners of the octagon showing the
embroidery area for the pattern are
indicated by changing direction.
Carefully watch the movement of the embroidery
frame and check that the embroidery is sewn in the
desired location and that the embroidery frame does
not hit the presser foot.
54
Temporarily stopping to check
the area
The embroidery frame can be temporarily stopped
at a desired position or the checking of the
embroidering area can be stopped.
a
When the embroidery frame moves to the
desired position, touch
→ The embroidery frame stops moving, and the next
screen appears.
2
1 Touch to continue moving the frame.
2 Touch to stop checking the embroidering area.
b
To continue moving the embroidery frame,
touch
. To stop checking the
embroidering area, touch
Continuing to the embroidering
screen
After finishing the necessary operations in the
embroidering settings screen, continue to the
embroidering screen.
a
Touch
.
→ The embroidering screen appears.
again.
1
.
Advertisement
Table of Contents
Troubleshooting
