Preparing The Spool Stand - Brother 884-T13 Operation Manual

c After the thread guide assembly support is
extended and the thread guide assembly is
raised to its highest position, tighten the
two thumb screws to secure the thread
guide assembly in place.
1 Thread guide assembly
2 Tighten screw.
3 Thread guide assembly support
Note
• If the thumb screws are not loosened
enough, it may not be easy to move the
thread guide assembly support. Do not
apply extreme force when moving the
thread guide assembly support. Be sure
that the thumb screws are loosened well
enough before moving the part.
• Be sure to tighten each thumb screw well
enough that the thread guide assembly
support is secured.

Preparing the spool stand

Secure the spool stand in place for embroidering.
Use the included disc-shaped screwdriver.
a Loosen the thumb screw two or three turns,
and then fold out the spool stand.
Rear view
1 Thumb screw
2 Spool stand
b After the spool stand is fully opened up,
tighten the thumb screw.
Rear view
→ Secure the spool stand in the opened position.
GETTING READY
1
29