Brother 884-T13 Operation Manual page 305

The machine needs maintenance.
(Refer to page 289.)
The machine was stopped while the
needle bar case was moving.
Touch to automatically reset the
needle bar case.
The combined character pattern is too
large to fit in the extra-large
embroidery frame.
Change the character pattern
combination.
Machine has recognized the
embroidery position mark.
Remove the embroidery positioning
sticker and touch to continue.
The combined character pattern is too
large for the embroidery frame.
Rotate the pattern 90 degrees and then
continue combining characters.
The motor has locked up due to tangled
thread or for other reasons related to
thread delivery.
If the thread is entangled in the bobbin
case, clean the race, and then oil it.
(Refer to page 286 and 289.)
APPENDIX
The machine is retrieving a previously
saved pattern.
The built-in camera is being used to
align the embroidery position, but the
embroidery positioning sticker is too
near an edge or the pattern extends
from the embroidery frame.
Change the position of the embroidery
positioning sticker, and then try aligning
the position again.
The USB media is write-protected.
Cancel the write protection.
7
303