Table of Contents
Advertisement
t
Use the clips to secure the cap.
1 Clips
• Attach the clips with their handles folded inward. If
the handles are pointed outward, they may be hit by
the machine's presser foot.
→ This completes the positioning of the cap in the cap
frame.
u
Return the cap frame to its original
position.
• While pulling the lever behind the handle on the right
side of the mounting jig toward you, rotate the cap
frame to the left. After the cap frame has been rotated
90° and the brim points up, release the lever to lock
the cap frame in place.
1 Handle
2 Lever
274
v
Remove the cap frame from the mounting
jig.
To remove the cap frame from the mounting jig, place
both thumbs on the holders on the mounting jig,
grasping the handles on both the right and left side of
the cap frame, gently pulling toward you. As shown in
the illustration.
1 Holder
2 Handle
■ Attaching the cap frame to the
embroidery machine
The cap frame driver is required in order to attach
the cap frame to the embroidery machine. Before
attaching the cap frame to the machine, attach the
cap frame driver to the carriage. (Refer to "Installing
the cap frame driver" on page 265.)
Before attaching the cap frame, adjust the position
of the cap supports to fit the type (size) of cap to be
embroidered. To adjust move the cap supports to
the front or back depending on the cap size.
a
Loosen the four screws on the cap supports
two or three turns, and then move the cap
supports to a position where tension in the
cap will be maintained.
• Do not remove any of the screws, otherwise they may
be lost. Only turn the screws to slightly loosen them.
1 Cap supports
2 Screws
3 Low profile (shorter caps)
4 Standard (taller caps)
• Be sure to adjust both the right and left cap supports
to the same position.
Advertisement
Table of Contents
Troubleshooting
