Download  Print this page

Changing The Pattern Size While Maintaining The Desired Thread Density (stitch Recalculator) - Brother 884-T13 Operation Manual

Hide thumbs

Advertisement

e
After making the desired changes, touch
.
→ The pattern editing screen appears again.
CAUTION
• After changing the size of the pattern, check
the icons for the embroidery frames that can
be used and use only the indicated frames. If a
frame other than those indicated are used, the
presser foot may hit the embroidery frame and
cause injuries.
Changing the pattern size while
maintaining the desired thread
density (stitch recalculator)
In the embroidery edit screen, the size of the
pattern can be changed while the desired thread
density is maintained.
With this function, the pattern will be enlarged or
reduced at a larger ratio than with normal pattern
resizing.
Note
• Patterns with a large number of stitches
(about 100,001 or more) cannot be resized
while maintaining a desired thread density.
The maximum limit for the number of
stitches differs depending on the data size
of pattern.
• If this function is used, thread density is
maintained while the pattern is enlarged/
reduced. However, the needle drop point
pattern is not entirely maintained. Use the
normal resizing mode
the results of trial embroidering.
a
b
c
depending on
d
SELECTING/EDITING/SAVING PATTERNS
Press
.
→ The following screen is displayed. (Refer to
page 178)
Press
to enter Stitch Recalculator
mode (
).
Memo
• Stitch Recalculator cannot be used if
does not appear.
When the following message appears, touch
.
→ The pattern will be returned to its original size,
angle, and position as it was before it was edited.
Select how to change the pattern size.
(Refer to page 178.)
5
179

Advertisement

Table of Contents

Troubleshooting

   Also See for Brother 884-T13

   Related Manuals for Brother 884-T13

   Related Content for Brother 884-T13

Comments to this Manuals

Symbols: 0
Latest comments: