If The Bobbin Thread Breaks Or Runs Out - Brother 884-T13 Operation Manual

If the bobbin thread breaks or
runs out
a Touch , and then press the thread
trimming button.
→ The upper thread is trimmed.
• If the bobbin thread breaks or runs out, also trim the
upper thread.
b Remove the stitches sewn only with the
upper thread.
Pull the trim end of the upper thread.
• If the stitches cannot be cleanly removed, trim the
thread with scissors.
118
■ If the bobbin thread ran out, replace
the bobbin at this point in the
procedure.
a Replace the bobbin with a bobbin wound
with bobbin thread. (Refer to page 36.)
• If the hook cover can be opened, replace the bobbin
without removing the embroidery frame from the
machine.
• If the machine bed is hidden, for example, with a bag-
shaped piece of fabric, or if the hook cover cannot be
opened, temporarily remove the embroidery frame.
(Refer to page 68.) After replacing the bobbin, re-
attach the embroidery frame. (Refer to page 50.)
Note
If the embroidery frame is removed before
embroidering of the pattern is finished, take
caution, otherwise the pattern may become
misaligned.
• Do not apply extreme pressure to the
framed fabric and cause it to become loose.
• When removing and re-attaching the
embroidery frame, do not allow the frame to
hit the carriage or the presser foot.
If the carriage is hit and moves, turn the
machine off, then on again. The correct
frame position at the time that the machine
was stopped is stored in the machine's
memory, and the embroidery frame is
returned to the correct position.
• When the embroidery frame is re-attached,
make sure that the pins on the left and right
arms of the embroidery frame holder
securely fit into the holes in the handles on
the embroidery frame.
b Go back through the stitching in the same
way as that described in step
upper thread breaks" on page 116, and then
continue embroidering.
b
of "If the