Download  Print this page

Resume Embroidering After Turning Off The Machine - Brother 884-T13 Operation Manual

Hide thumbs

Advertisement

Resume Embroidering After Turning Off the Machine

In either of the following cases, the remaining stitches of the embroidery are stored in the machine's
memory.
• If the machine's power switch is pressed to turn off after stopping embroidering.
Cut the thread before the machine's main power switch is turned off, otherwise the thread may be pulled or may catch
when the carriage returns to its initial position after the machine is turned on again.
• If the machine was accidentally turned off, for example, due to a power outage, while it was embroidering.
The remainder of the embroidery can be sewn when the machine is turned on again; however, some of the stitches that
were already sewn may be sewn again.
Note
• Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
a
Set the main power switch to "I" to turn on
the machine.
b
When the machine is turned on, the
opening movie is played. Touch anywhere
on the screen to display the message below.
c
Touch
.
→ A message appears, asking if you wish to continue
embroidering or start a new operation.
122
d
Touch
.
1 Touch to cancel embroidering and display the
pattern type selection screen to select a new
pattern.
2 Touch to continue embroidering.
→ The embroidering screen displayed before the
machine was turned off appears.
e
Touch
.
→ The stitch navigating screen appears.
1
2

Advertisement

Table of Contents

Troubleshooting

   Also See for Brother 884-T13

   Related Manuals for Brother 884-T13

Comments to this Manuals

Symbols: 0
Latest comments: