Download  Print this page

Cleaning Around The Needle Plate - Brother 884-T13 Operation Manual

Hide thumbs

Advertisement

Cleaning around the needle plate

If lint and dust collect around the moving knife,
the fixed knife or the thread retaining plate, the
thread may not be cut correctly and the error
message may appear, or various parts of the
machine may be damaged. Make sure to clean
around the needle plate once a month.
Use on offset screwdriver and the included
cleaning brush.
a
Turn off the embroidery machine.
CAUTION
• Unplug the power supply cord before cleaning
the machine, otherwise injuries or an electric
shock may occur.
b
Remove the needle plate.
With an offset screwdriver, loosen the screws, and
then remove the needle plate, and then open the hook
cover.
1 Needle plate
2 Hook cover
c
Remove the spacer.
1 Spacer
d
Use the included cleaning brush to remove
any lint and dust from the moving knife, the
fixed knife, the thread retaining plate, and
their surrounding areas.
1 Remove all lint in this area
e
After cleaning is finished, install the spacer
back.
First, position the spacer so that it hooks around the
elliptical notch, then position the spacer so that it
surrounds the screw head. Slide the spacer in the
direction of the arrow to secure it.
1 Elliptical notch
2 Screw head
APPENDIX
7
285

Advertisement

Table of Contents

Troubleshooting

   Also See for Brother 884-T13

   Related Manuals for Brother 884-T13

Comments to this Manuals

Symbols: 0
Latest comments: