Table of Contents
Advertisement
b
Move the left arm to align the screw on the
right side with the mark for the embroidery
frame to be installed, and then tighten the
thumb screws.
For this example, align with mark 5.
1 Mark for extra-large embroidery frame
200 mm (H) × 360 mm (W)
(7-7/8 inches (H) × 14 inches (W))
2 Mark for extra-large embroidery frame
200 mm (H) × 300 mm (W)
(7-7/8 inches (H) × 11-3/4 inches (W)) (optional)
3 Mark for large embroidery frame
130 mm (H) × 180 mm (W)
(5-1/8 inches (H) × 7-1/8 inches (W))
4 Mark for medium embroidery frame
100 mm (H) × 100 mm (W)
(4 inches (H) × 4 inches (W))
5 Mark for small embroidery frame
40 mm (H) × 60 mm (W)
(1-1/2 inches (H) × 2-3/8 inches (W))
Note
• Please firmly tighten the two thumb screws
with included disc-shaped screwdriver. If
the thumbscrews are not tightened, any of
the following problems may occur.
• The machine will detect the embroidery frame
size incorrectly.
• The starting position for the embroidery frame
is misaligned.
• The embroidery pattern is misaligned.
→ The embroidery frame holder is ready for the
embroidery frame to be attached.
EMBROIDERING TUTORIAL
c
Hold the embroidery frame level, and then
simultaneously align both the left and right
mounts with the embroidery frame holder
clips.
• The inner frame should be on top.
Note
• Attach the embroidery frame to place the
needle plate under the embroidering area
otherwise the embroidery frame hits the
needle plate.
1 Needle plate
• If the outer frame is on top, as shown
below, the embroidery frame is incorrectly
attached.
d
Insert the embroidery frame until it snaps
into place.
1 Make sure that the pins on the left and right arms
of the embroidery frame holder fit into the
positioning slot and hole on the embroidery frame.
2
51
Advertisement
Table of Contents
Troubleshooting
