Download  Print this page

Connecting The Usb Using The Included Usb Cord Clamps - Brother 884-T13 Operation Manual

Hide thumbs

Advertisement

Connecting the USB using the
included USB cord clamps
When connecting the embroidery machine to a
computer, use the included USB cord clamps to
keep the cord away from the carriage.
Included cord clamps
Installation positions of the USB cord clamps
1 Front screw hole on the side of the machine
2 Rear screw hole on the side of the machine
a
Using the included Allen screwdriver,
remove the protective cap covering the
front screw on the side of the machine.
• Insert the end of the Allen screwdriver into the hole in
the protective cap, and then lightly pull out the
protective cap to remove it.
Note
• Do not insert the Allen screwdriver too far
into the hole in the protective cap;
otherwise, the machine or the Allen
screwdriver may be damaged.
1
2
SELECTING/EDITING/SAVING PATTERNS
b
Open the USB cord clamp.
• With your fingernail, press on the tab to open the
clamp.
1 Tab
c
Hold the clip end of the USB cord clamp,
and then firmly insert the other end into the
screw hole where the protective cap was
removed.
d
As described in steps
remove the protective cap from the rear
screw hole on the side of the machine, and
then insert an opened USB cord clamp.
1
a
c
through
,
163
5

Advertisement

Table of Contents

Troubleshooting

   Also See for Brother 884-T13

   Related Manuals for Brother 884-T13

Comments to this Manuals

Symbols: 0
Latest comments: