Brother 884-T13 Operation Manual page 212

m After the two positioning stickers have been
detected, the following message appears.
1
1 Embroidering area
While making sure that the two positioning stickers do
not peel off, remove the embroidery frame from the
machine, and then rehoop the fabric. Be sure to hoop
the fabric so the next pattern and both the positioning
stickers are within the embroidery sewing area.
Reattach the frame and press
2 Pattern to be embroidered next
3 Centers of large circles for stickers
4 Embroidery sheet
→ The camera detects the two positioning stickers.
210
.
Note
• If the next pattern and the centers of the
large circles of the two positioning stickers
do not fit within the embroidering area, use
a larger embroidery frame. If a larger
embroidery frame cannot be used, continue
n
to step , and then refer to "Changing the
position of a sticker" on page 212 to
reposition the sticker.
• If the sticker peels off during this procedure,
the patterns cannot be connected. If this
occurs, restart the procedure from the
beginning.
• If either of the following messages appear,
rehoop the fabric so that the next pattern
and both the positioning stickers are within
the embroidery sewing area as indicated in
the screen.
Touch to detect the positioning
stickers.