Download  Print this page

Setting The Machine To Stop At Color Changes; Stopping The Machine At The Next Color Change; Specifying Pause Locations Before Embroidering - Brother 884-T13 Operation Manual

Hide thumbs

Advertisement

Setting the Machine to Stop at Color Changes

The machine can be stopped at any time; however, if the machine is stopped while it is embroidering, it
is better to go back a few stitches before continuing sewing to overlap the stitching. If the machine stops
at a color change, it is not necessary to go back through the stitching before continuing embroidering.
Stopping the machine at the next
color change
The machine can be set to stop before sewing the
next color.
a
While sewing the color before the point
where you wish to stop the machine, touch
so that it changes to
b
After finishing sewing the area for the
current color, the next needle bar moves
into position and the machine stops before
sewing the next color.
changes back to
• If the machine is temporarily turned off, you will be
asked if you wish to continue sewing or select a new
pattern when the machine is turned on again.
Touch
to continue embroidering. (Refer to
"Resume Embroidering After Turning Off the
Machine" on page 122.)
140
.
.
Specifying pause locations before
embroidering
Pause locations can be specified in the pause
setting screen, displayed by touching
a
Touch
in the embroidering settings
screen.
→ The change thread color screen appears.
b
From the thread color sequence display,
select the thread color where you wish to
stop the machine before sewing it.
• If the desired thread color is not displayed, use the
scroll bar on the right side to display it.
1
1 Scroll bar
.

Advertisement

Table of Contents

Troubleshooting

   Also See for Brother 884-T13

   Related Manuals for Brother 884-T13

Comments to this Manuals

Symbols: 0
Latest comments: