Brother 884-T13 Operation Manual page 211

Note
• Use new positioning stickers. If a sticker is
reused, it may easily peel off. If the sticker
peels off during this procedure, the patterns
cannot be connected. Start the project
again with new fabric and stabilizer.
• Using fingers apply pressure to the corners
of the positioning sticker to firmly affix it to
the fabric. If the sticker is not firmly
attached, the camera may incorrectly detect
the sticker.
• If any of the following messages appear,
reattach the positioning sticker in the
correct position. Make sure that the sticker
is affixed with the large circle at the top.
SELECTING/EDITING/SAVING PATTERNS
l Using both hands affix the second
embroidery positioning mark within the red
lines by pressing down on each corner of
the positioning mark onto the material and
then touch .
→ The camera detects the second positioning sticker.
5
209