Download  Print this page

Advertisement

Symptom
After the threads are
automatically cut, the
Lint or dust has accumulated around
upper thread is too
the needle plate (moving knife, fixed
short and comes out of
knife or thread retaining plate).
the needle.
The needle is not correctly installed.
The needle set screw is loose.
The needle is bent or blunt.
The area around the hole in the needle
plate is damaged.
The needle is touching the needle
plate.
The upper thread
breaks.
The presser foot is set too high and not
correctly positioned.
The needle hits/touches the presser
foot.
The area around the embroidery foot
hole is damaged.
Using a specialty thread like a metallic
thread.
Probable Cause
1 Scratches/Burrs
1 Needle
2 Needle plate hole
3 Needle touching hole
1 Scratches/Burrs
Remedy
Remove any lint or dust around the
needle plate.
Correctly install the needle.
Use the Allen screw driver to tighten
the needle set screw.
Replace the needle with a new one.
Replace the needle plate or consult
your nearest authorized Brother dealer.
Consult your nearest authorized
Brother dealer.
Consult your nearest authorized
Brother dealer.
Replace the presser foot.
Consult your nearest authorized
Brother dealer.
Slow down the machine sewing speed.
APPENDIX
Reference Page
p.285
p.86
p.86
p.33, 86
7
p.139
293

Advertisement

Table of Contents

Troubleshooting

   Also See for Brother 884-T13

   Related Manuals for Brother 884-T13

Comments to this Manuals

Symbols: 0
Latest comments: