Cal Oscillator Control - Agilent Technologies 8564EC Service Manual

Adjustment/Diagnostic Software
To Use the Diagnostics

Cal Oscillator Control

1. Using another spectrum analyzer, look at the output of the cal
Figure 2-9 CAL Oscillator Swept Output, 20 kHz Width
2. Use the up/down arrows ( ,
3. Use the left/right arrows ( ,
You can select sweep width only when CF is at 10.7 MHz.
NOTE
84
oscillator. Refer to the A4 schematic diagram in the
Spectrum Analyzer Component Level Information and 8560 E-Series
Spectrum Analyzer Component Level Informatio
spectrum analyzer should be similar to that shown in
page 84.
CF, Sweep Width, or RF On/Off for the cal oscillator.
selection.
n. The display on the test
) on the controller keyboard to select
) to change parameters within each
8560 EC-Series
Figure 2-9 on
Chapter 2