Phase Noise Problems; Phase Noise In Locked Versus Unlocked Spans - Agilent Technologies 8564EC Service Manual

Phase Noise Problems

System phase noise can be a result of noise generated in many different
areas of the spectrum analyzer. When the spectrum analyzer is
functioning correctly, the noise can be observed as a function of the
distance away (the offset) from the carrier frequency. The major
contributor to system noise can be characterized as coming from specific
circuit areas depending upon the offset frequency.
Some very general recommendations can be made for identifying which
circuitry is the cause of the noise at certain offsets. The
recommendations below apply with a center frequency of 1 GHz.
Table 11-15 Settings of Sweep Switches
Carrier Frequency Offset
100 Hz
1 kHz
3 kHz
10 kHz to 150 kHz
>150 kHz

Phase Noise in Locked versus Unlocked Spans

Input a signal to the spectrum analyzer. Set the center frequency to the
input signal frequency, set the span to 2 MHz, and plot the display. This
plots the system noise for a locked sweep. Plot the display again with a
span of 2.01 MHz (lock and roll sweep).
The crossover point of the noise floor of the two plots is typically at an
offset of about 50 kHz, for a functioning instrument.
If the crossover point is shifted out to a higher offset frequency, suspect
the YTO loop circuitry.
If the crossover point is shifted in to a lower offset frequency, suspect
the offset or fractional N loop circuitry.
Chapter 11

Phase Noise Problems

Major Contributor (when
working correctly)
Reference (OCXO or TCXO)
reference PLL
100 MHz
Fractional N PLL
Offset lock loop or YTO loop
YTO
Synthesizer Section
575