Table of Contents
Advertisement
Adjustment/Diagnostic Software
4. LOMA Adjustments
4. LOMA Adjustments
Assembly Adjusted
A14 frequency control assembly
Related Performance Test
1ST LO OUTPUT Amplitude
Procedure
When connecting the 8587A power sensor to the 1 ST LO OUTPUT, be
CAUTION
sure to use proper adapters. Failure to do so will result in damage to the
expensive connector of the power sensor.
On the DVM, "Front terminals" must be selected or the adjustment
NOTE
program will not run.
Figure 2-4
A14J18 and A14J15 Pin Locations
68
Carefully follow the instructions issued by the software program.
See
Figure 2-4 on page 68
for test connector pin locations.
Chapter 2
Advertisement
Chapters
Table of Contents
Troubleshooting
