To Use The Adjustment Program - Agilent Technologies 8564EC Service Manual

9 .At the prompt "Enter power sensor model #. Example, 8487",
10
When entering the power sensor calibration data, be sure to enter the
NOTE
50 MHz calibration factor. The 50 MHz calibration factor is not always
explicitly listed in the table included with the power sensor, but is
referred to as the "REF CF" (reference calibration factor).
When entering the power sensor calibration data for the 8487A, be sure
to also enter a 10 MHz calibration factor. The standard 8487A is
calibrated only down to 50 MHz, but the software uses it down to
10 MHz.
The calibration data does not have to be entered in frequency order.
Frequencies may be entered in any order.
When editing, use the arrow keys ( ,
want to edit. Use the
new characters.
11
12
13
14
15
16

To Use the Adjustment Program

1. MSI to the parent directory (created in "To Load the Program", step
2. Type LOAD "MANAGER/MANAGER",1 and press
3. Press Set inst addr.
Chapter 2
enter the first 4 digits of the model number of the power sensor for
which you are entering calibration data. Do not enter any alpha
characters; the power sensor model must be 4 digits. You will then be
prompted to enter the last four digits of the power sensor serial
number. For example, if the serial number is 2937A00564, enter
0564.
.Press Edit Sensor.
Backspace
.Enter the frequency (in MHz) and press
.Enter the calibration factor (for the corresponding frequency) and
press (or
RETURN ENTER
.Repeat steps 17 and 18 for all calibration points. Press "Q" when
done.
.Press Store Sensor when finished entering data for each power
sensor.
.Repeat steps 13 through 19 for any other power sensors that will be
used.
.Press quit.
2).
Using the Adjustment/Diagnostic Software
) to get to the entry that you
key to delete characters, then enter
RETURN
).
Adjustment/Diagnostic Software
(or ).
ENTER
(or
RETURN EXECUTE
).
59