Table of Contents
Advertisement
General Troubleshooting
Error Messages
109 CtrlFail Spectrum analyzer unable to take control of the bus.
110 NOT CTRL Spectrum analyzer is not system controller.
111 # ARGMTS Command does not have enough arguments.
112 ??CMD?? Unrecognized command.
113 FREQ NO! Command cannot have frequency units.
114 TIME NO! Command cannot have time units.
115 AMPL NO! Command cannot have amplitude units.
116 ?UNITS?? Unrecognizable units.
117 NOP NUM Command cannot have numeric units.
Enable parameter cannot be used.
118 NOP EP
119 NOP UPDN UP/DN are not valid arguments for this command.
120 NOP ONOF ON/OFF are not valid arguments for this command.
121 NOP ARG AUTO/MAN are not valid arguments for this command.
122 NOP TRC Trace registers are not valid for this command.
123 NOP ABLK A-block format not valid here.
124 NOP IBLK I-block format not valid here.
125 NOP STRNG Strings are not valid for this command.
This command cannot be queried.
126 NO ?
127 BAD DTMD Not a valid peak detector mode.
128 PK WHAT? Not a valid peak search parameter.
129 PRE TERM Premature A-block termination.
130 BAD TDF Arguments are only for TDF command.
131 ?? AM/FM AM/FM are not valid arguments for this command.
132 !FAV/RMP FAV/RAMP are not valid arguments for this command.
133 !INT/EXT INT/EXT are not valid arguments for this command.
134 ??? ZERO ZERO is not a valid argument for this command.
135 ??? CURR CURR is not a valid argument for this command.
136 ??? FULL FULL is not a valid argument for this command.
137 ??? LAST LAST is not a valid argument for this command.
138 !GRT/DSP GRT/DSP are not valid arguments for this command.
139 PLOTONLY Argument can only be used with PLOT command.
140 ?? PWRON PWRON is not a valid argument for this command.
328
Chapter 7
Advertisement
Chapters
Table of Contents
Troubleshooting
