Equipment; Procedure - Agilent Technologies 8564EC Service Manual

Equipment

Procedure

This adjustment cannot be performed if preselected external mixer
NOTE
mode is selected.
The
YTO Main Coil Adjustments
1. Press
2. Disconnect the 50Ω termination from the 1ST LO OUTPUT. Connect
3. Move the jumper on A14J23 from the NORM position (pins 1 and 2
4. On the spectrum analyzer, press the following keys:
5. On the 5343A, press
Chapter 3
Microwave frequency counter ....................... 5343A Option 001
Adapters
Type N (m) to BNC (f) ................................................... 1250-1476
Type N (f) to 2.4 mm (f) ...................................................... 11903B
APC 3.5 (f) to APC 3.5 (f) .............................................. 5061-5311
Cables
BNC, 122 cm (48 in) ........................................................... 10503A
SMA, 61 cm (24 in) ........................................................ 8120-1578
SAVELOCK ON OFF
to turn the spectrum analyzer off. Remove the spectrum
LINE
analyzer cover and fold down the A15 RF and A14 frequency control
assemblies.
the equipment as shown in
turn the spectrum analyzer on.
jumpered) to the TEST position (pins 2 and 3 jumpered). See
3-14"YTO Adjustment Locations," on page 132
A14 frequency control assemblies.
,
CONFIG EXT MXR PRE UNPR
, 6 Hz
LOCK HARMONIC
, 18.8893 GHz,
FREQ
, 35.7493 GHz
FREQUENCY
,
RECALL STATE STATE 0
Sample rate .......................................... Fully counterclockwise
10 Hz−500 MHz/500 MHz−26.5 GHz switch ......
500 MHz-26.5 GHz
function must be OFF.
Figure 3-13 on page
, (UNPR)
AUX CTRL
,
SPAN ZERO SPAN FREQUENCY
,
SGL SWP SAVE SAVE STATE
,
SAVE SAVE STATE
.
7 and set the controls as follows:
SHIFT
Manual Adjustment Procedures
5. YTO Adjustment
130. Press to
LINE
Figure
for the location on the
,
EXTERNAL MIXER
,
CENTER
,
STATE 0
, ,
STATE 1 RECALL
131
,