Equipment - Agilent Technologies 8564EC Service Manual

Manual Adjustment Procedures
11 . External Mixer Amplitude Adjustment

Equipment

Synthesized sweeper ..................................................... 8340A/B
Measuring receiver ........................................................... 8902A
Power sensor ...................................................................... 8481D
50 MHz reference attenuator ......................................... 11708A
(supplied with 8481D)
Adapters
Type N (f) to SMA (f) ................................................... 1250-1772
Type N (m) to BNC (f) ................................................. 1250-1476
Type APC 3.5 (f) to APC 3.5 (f) .................................. 5061-5311
Type N (f) to 2.4 mm (f).................................................... 11903B
Cables
BNC, 122 cm (48 in) ......................................................... 10503A
SMA, 61 cm (24 in) ...................................................... 8120-1578
Procedure
1. Press to turn the spectrum analyzer off and disconnect the
LINE
power cord. Remove the spectrum analyzer cover and reconnect the
power cord.
2. Set up the equipment as illustrated in
not connect the SMA cable to the spectrum analyzer.
3. Move the WR PROT/WR ENA jumper on the A2 controller assembly
to the WR ENA position. The jumper is on the edge of the A2 board
assembly and can be moved without folding the board down.
4. Press to turn the spectrum analyzer on. On the spectrum
LINE
analyzer, press
CONFIG
,
EXTERNAL MIXER
⇓ ⇓
5. Press or to display the conversion loss value for each frequency
listed in Table 3-10 on page
not equal to 30 dB in
frequency.
148
Figure 3-21 on page
,
EXT MXR PRE UNPR
, then
AMPTD CORRECT
149. Record any conversion loss reading
Table 3-10 on page 149
147. Do
(UNPR),
AUX CTRL
.
CNV LOSS VS FREQ
at the appropriate
Chapter 3
,