Table of Contents
Advertisement
12-Bit Flash ADC
The flash ADC (U22) converts the analog video signal into 12-bit digital
values at a fixed rate of 12 megasamples per second.
When measuring voltages or waveforms on the Fast ADC of the A2
controller assembly, connect the ground (or common) lead to the
ground-plane trace associated with the shield. This digital ground
plane is totally isolated from the chassis.
1. Press
on the spectrum analyzer and set the controls as
PRESET
follows:
Center frequency ..................................................... 300 MHz
Span ................................................................................. 0 Hz
Reference level ......................................................... −20 dBm
Log/division .............................................................. 5 dB/DIV
Sweep time .................................................................... 20 ms
2. Connect the CAL OUTPUT to the INPUT 50Ω connector.
3. Pins 2 through 13 (ADC0-ADC11) of U22 should all be high (logic 1),
corresponding to an ADC digital count of 255 for the analog input of
+2 volts or greater.
4. Disconnect the CAL OUTPUT signal from the INPUT 50Ω
connector.
5. Pins 2 through 13 (ADC0-ADC11) of U22 should all be low (logic 0),
corresponding to an ADC digital count of zero for the analog input of
0 volts or less.
Chapter 10
Controller Section
12-Bit Flash ADC
511
Advertisement
Chapters
Table of Contents
Troubleshooting
