Tavve zoneranger User Manual page 311

The required format for subnet or IP address entries in the input file is the same as for the
add-route
from a specific line of
gvi list-routes [-all]
-
all
the system routing table that appear to have been created manually.
gvi list-routes
If the GVI service is enabled, the listed routes will also include any ZoneRanger host routes that
have been created by the route manager. If the -
also include any virtual interface routes or ZoneRanger host routes in the system routing table
that appear to have been created manually. Each such address will be prefixed by a + (plus)
character in the resulting list, in order to distinguish these routes from the routes that have been
created by the GVI route manager.
gvi clear-routes [-f]
gvi clear-routes
the -f option is specified, the user is not prompted for confirmation.
gvi config [ item [ value ]]
gvi config
vice.
The configuration items associated with the GVI service are:
Item
log_level
If no item or value is specified, the values of all configuration items are listed. If an item is
specified with no value, the current value of the specified configuration item is displayed. If an
item and a value are specified, the value of the specific configuration item is set to the specified
value.
gvi test < address >
address indicates the individual IP address to verify.
gvi test
properly so that traffic send to a specified address will be intercepted, routed to an appropriate
ZoneRanger, and forwarded to the intended device. The
whether or not the specified address is managed by a ZoneRanger where applicable.
joinRequest
joinRequest address [ passcode ]
address
passcode
joinRequest
ZoneRanger 5.5 User's Guide
command with one entry per line. Note, if there is an error adding a GVI route
input-file ,
lists all routes which include any virtual interface routes or ZoneRanger host routes in
subcommand lists all IP addresses and subnets in the GVI route list.
subcommand removes all IP addresses and subnets in the GVI route list. If
can be used display or modify configuration items associated with the GVI ser-
Value
Determines the level of logging for the GVI
service – values: none, short , full.
is none.
can be used to verify that the GVI and Proxy Map services have been configured
indicates the hostname or IP address of the ZoneRanger to contact.
indicates the security passcode to use with the specified ZoneRanger
attempts to join to a ZoneRanger.
processing will continue on subsequent lines.
option is specified, the listed routes will
all
gvi test
gvi
Default
subcommand also verifies
311