Tavve zoneranger User Manual page 144

Figure 34-32. Configuration > Forwarding page
Configuring forwarding rules
The Configuration > Forwarding page Forwarding Rules tab allows the creation of
forwarding rules associated with each Ranger Gateway or Destination Group. Each entry in the
forwarding rules table consists of the following:
Field
Enabled
Type
Source Addresses
Local Port
Destination Host
(Ranger Gateway
Only)
Destination Port
Filter
Additional Trap Filtering
When configuring a trap forwarding rule, the Filter column for the corresponding row in the
rules table contains a pulldown list of defined trap filters, and an Options button, that can be
used to configure additional forwarding options.
The pulldown list contains the list of trap filters defined on the ZoneRanger. ZoneRanger
provides a base set of trap filters which cannot be deleted. You can use this list to select the trap
filter to be applied for the rule you are defining.
The Options button provides the following set of trap conversion options:
ZoneRanger 5.5 User's Guide
Description
Whether or not this forwarding rule is
currently active
Trap, Syslog, NetFlow, sFlow, Generic
Source addresses of the data coming in
to ZoneRanger. Addresses are separated
by commas and may be an address pattern
or Node Group.
The local port ZoneRanger is listening
on for this traffic
Hostname or IP address that will
ultimately receive the data. Must be
reachable by the Ranger Gateway.
Port on the Destination Host where the
data will be sent.
Additional filtering options for Trap
and Syslog.
144